A Process Starting with Technical Data
Manufacturing from Drawings, Samples or Defined Requirements
Manufacturing can begin from a completed technical file, physical sample or defined function. Where required, the design is developed and material and machining decisions are established for the component to be produced.
Input Data
The Starting Point Is the Available Data
Input data may vary according to project scope. Available information is reviewed for manufacturing, and missing technical details are identified during the initial evaluation.
01
Technical Drawing
Dimensions, tolerances and defined technical information relating to the part.
02
3D File
A digital model supporting evaluation of part geometry and manufacturing.
03
Physical Sample
An existing sample from which dimensions, geometry and signs of use can be examined.
04
Existing Part
A component requiring reproduction or evaluation according to its operating conditions.
05
Defined Application
Information on the part’s function, the system in which it will operate and the requirement it is expected to meet.
Manufacturing Approach
Preparing the Manufacturing File
01
Data Review
The supplied file, sample or existing part is reviewed in terms of dimensions and function.
02
Defining Technical Requirements
Tolerances, material, contact, motion and environmental effects are defined.
03
Design and Manufacturing Decisions
The required geometry is developed and the appropriate machining method selected.
04
Completing the Technical File
The approved solution is prepared for one-off or repeat manufacturing.
Begin with the Available Data
Incomplete Data Does Not Stop the Process
If the drawing or model is incomplete, a sample and application information may be sufficient for the initial review.
Required dimensions, material properties and acceptance criteria are clarified before manufacturing.
Initial Evaluation
Information Required for Technical Evaluation
- Application area and function of the part
- Technical drawing or 3D file, if available
- Material information or operating conditions
- Required quantity
- Expected delivery date
Technical Evaluation
Begin with the Available Data
A technical file, sample or application description can be provided. The initial review identifies any additional information required and the manufacturing route to be followed.